XCMAN Alpine Freeride Snowboard Ski Base Ptex Base Repair Kit: 5 ptex ski Base Repair Candle, Metal Scraper, Sanding Sponge

• PTEX 5 pieces ,Metal scraper and sanding paper.Nice ski base repair kit,save time and save money.
• PTEX Transparency/Clear color, perfect for clear ski bases repair.
• PTEX Size:8mm(0.314 inch) diameter. 195mm(7.67 inch) length;Metal Scraper size:L130 mm long (5.11 inches).
• One sanding Sponge(Mediu Grit 1000-800) for removed rust and polising steel edge.For fine buffing of edges. A few strokes will shine an edge.
• Easy carry and use. Save your money and value time by fixing your own ski and snowboard bases at home or outdoors.

Everything you need to repair ski and snowboard bases: PTex; Metal Scraper; Sanding Sponge(for removed rust and polising edge).Choose black ptex for black base areas and clear ptex for clear or colorized base areas. If you need both clear and black ptex we offer a 3/3 mix. Kit listing: PTex Rods for base repairs.Diameter 8 mm; Length:19.8mm.Use this for PTex work on ski and snowboard bases.Suitable for light base planing. Metal base scraper:L130 mm long (5.11 inches). One sanding Sponge(Mediu Grit 1000-800) for removed rust and polising steel edge.For fine buffing of edges. A few strokes will shine an edge.PTEX Choose from 5 Black, 5 Clear, or 3/3 Black/Clear mix. Our 5pcs pack of XCMAN PTEX will help you make consistent base repairs all season long. Match the ptex candle color with your ski snowboard easily and seamlessly when the repair job is complete. These 8mm diameter ptex candle are just what you need to keep having fun all season long. Use our hot spot torch for burning clean ptex is best choice, it can reduce ptex oxidation or ptex anti black carbon. Color Available:Black and White.Please as per your Ski base to chose. Use a torch to light the Ptex candle, keep the candle very close to the metal scraper to keep it from oxidize, so that the drip candle can maintain very good quality. Hold at a 45° angle about 1\" above the gouge (you want a blue flame, not yellow,adjust height to achieve this. drip the candle into the gouge carefully. Wait for the candle to cool down (about 10-15 minutes) after the gouge in filled. then use a metal scraper to remove the excess ptex candle. WARNING!! They burn extra-hot (in excess of 970°F) which helps consume some of the undesirable black carbon created while the candle burns.