WAN2TLK Thread Lock Blue 50ml, Medium Strength Locktight Threadlock, Removable Threadlocker, Lock & Seal Nuts, Bolts, Fasteners and Metals, High-Temperature, Against Losening Anti-Rust

• Thread lock: Blue thread lock has strong adhesion and can fix screws, nuts, and metal fasteners to prevent loosening due to vibration. Using locktight threadlock cores instead of solid gaskets, close contact, perfect sealing, and effective leakage prevention.
• Designed For Screw Nnut: WAN2TLK thread locks can not only lock metal parts, but also prevent screw rust and corrosion. At the same time, our locktight threadlock also has mild oil anti -pollution and high temperature resistance, and its applicable range is wider.
• Simple Use: Simply apply the threadlocker evenly to the thread, tighten the nut, and cure initially for 20 minutes, then fully cure within 24 hours. Note: Do not mix with metal, oil and dirt.
• Widely Uses: Lock tight thread lock family must-have to Etend the Life of Items and Safe Using! Whether you're installing a valve cover, water pump, or just tightening down some furniture screws, thread lock blue has you covered.
• Half-Bottle Package: Lock tight thread lock is anaerobic, so the bottle can not be filled, it need to leave almost half of the space, to avoid the threadlock curing and affecting the use. There is enough 50ml of thread lock in the bottle.

Locktight Threadlock: WAN2TLK lock tight thread lock, also known as screw fasteners or anaerobic adhesive, provides a strong and consistent lock that keeps everything firmly in place. No more worrying about tangled threads and unstable nuts or bolts. Thread locker medium strength is suitable for bolts below M20, meeting the needs of most bolts in daily life, and has a heat resistance of 150℃, enhancing its widespread and reliable application. WHY IS THE BOTTLE NOT FULL? Threadlockers are anaerobic, and anaerobic sealants are single-component adhesives that remain liquid when exposed to air, requiring air to remain liquid and prevent solidification and hardening. Use Steps: 1.Keep the surface clean 2.Apply a sufficient amount of threadlocker agent at the end of the screw 3.After applying the thread lock blue agent, tighten the nut to the locking agent position in 3 minutes by adjusting the angle, no further adjustments after curing 4.Wait for 20 minutes for the initial curing, and 24 hours after the complete curing, which prevents loosening and rust and corrosion Attention: 1. Do not mix with metal, oil and dirt 2. Pipe threads above Dn65 must be coated with adhesive on both sides, otherwise joint leakage may occur Do not pour the unused glue back to avoid contamination;