ieron Network Cable Tester, Wire Tracker Network Tester Kit to Test Circuit Continuity for Network, RJ11 Plug&Alligator Clips, Telephone Line, Cable Finder Tone Generator Probe Tracer

• Package List-- You will get 1 x Cable tracker sender emitter with two clips and RJ-11 plug, 1 x Cable tracker receiver, 1 x user manual, 1 x tool bag.
• Feature -- Perfect for installing, debugging, and maintaining telephone lines and other wires or cables.
• How it works -- The wire toner tracer receiver is equipped with an adjustable sensitivity dial, which allows you to accurately trace a wire in congested places. And also, you can use the wire toner to find an intermittent circuit problem. Just flex wires or connectors, and then you will hear that there is a change in the receiver tone.
• Note --Two 9V batteries are required, batteries are not included, and the probe does NOT NEED to touch the wire to pick up a tone. Non-contact probe audibly identifies selected wire or cable.
• Tone Tracing Probe Kit-- In TONE mode, you can quickly track cables passing through ceilings, under floors, interior wall barriers, etc., without the risk of not knowing the exact location of the wires (only one alligator clip is used in TONE mode).

Package List: 1 ieron Cable tracker sender emitter with 2 alligator clips & RJ-11 plug 1 ieron Cable tracker receiver 1 ieron user manual 1 ieron tool bag Packaging size: 255 * 120 * 36mm Packaging weight about: 0.26KG (not including battery!!!) Item Descriptions: -The cable tracker is designed to identify and trace wires or cables within a group simply by attaching the sender to the cable at one end and then touching the cables at the other end with the receiver to confirm which is the correct cable, without damaging the insulation. -For telephone lines, it can identify some states in the line and can help to install, debug, and maintain the telephone line. -Always turn off the power before using any mains cables. -Signal Detector Non-contact probe audibly identifies selected wire or cable. Rotate the volume/sensitivity control on the probe for the appropriate level and sensitivity to identify and trace the wire. -Signal Sender Switch to Tone Mode and use only one alligator clip to Trace Wire. Switch to Continuity Mode and use both alligator clips to check for continuity and short circuits. -Alligator Clips In Tone mode connect the red clip to the Wire you wish to trace and the black clip to the ground if possible. In Continuity mode connect each clip to each end of the circuit cable. If the wire is short-circuited or broken the Red LED with light. You can then use Tone mode to trace the wire all the way to the break location. -RJ-11 Plug Use the RJ-11 plug to identify ring and tip telephone lines and test the line condition (clear, busy, ringing).